联系我们

保定巨盛模具制造有限公司

电话:13833064090

电话:15188633222

联系人:高经理

地址:保定市清苑区阎庄乡中阎庄工业区

新闻动态
在模具设计中我们需要注意的有
在模具设计中我们需要注意的有:
In the mold design we need to pay attention to:
1、一般平板成品不宜中间进胶,以防弯曲变形。
1, general flat products should not be inserted into the middle to prevent bending deformation.
2、一仍般情况下STP在RP正下方。
2, one is still like STP under RP.
3、当模座较大时,STP的间隔为150--200mm。
3. When the die base is large, the interval between STP is 150--200mm.
4、锁上下顶出板的螺丝间隔为150--200mm。
4. The screw spacing between the upper and lower locking plates is 150--200mm.
5、当有顶针在滑块下方或斜梢有靠破时,上下顶出板要装有强制回位机构。
5, when there is a thimble under the slider or inclined pin, the upper and lower ejector plates must be equipped with a forced return mechanism.
6、成品拔模斜度以减胶为基准。
6. The slope of the finished product is based on reducing the glue.
7、设计水路时,尽量不要采用水管直接接入模仁,而改用模进水管用ORING联接模仁。
7, when designing waterways, try not to use water pipes to directly access molds, instead of using ORING to connect molds.
8、SP尽量将其直径取大并布置在成品的正投影面积下方。
8, SP try to enlarge its diameter and lay it under the positive projection area of the finished product.
9、冷却水路三原则﹕A.快速冷却,B.均匀模温,C.加工方便。
9, cooling water three principles: A. fast cooling, B. uniform mold temperature, C. processing convenience.
10、斜梢距模具中心应取整。
10. The center of the oblique tip should be taken out of the mold center.
11、支撑柱(SP)的摆放与脚垫间距应量保持相等,使其模具保持平衡。
11, the support column (SP) should be kept equal to the distance between the pads, so that the mold can be kept in balance.
12、KO孔随注口衬套的偏心而偏心,且注口衬套的最大倾斜角度不得大于15°。
12. The KO hole is eccentricity with the eccentric of the nozzle bushing, and the maximum inclination angle of the nozzle bushing should not be greater than 15 degrees.

联系方式

  1. 保定巨盛模具制造有限公司
  2. 电话:13833064090
  3. 电话:15188633222
  4. 联系人:高经理
  5. 地址:保定市清苑区阎庄乡中阎庄工业区

版权 © 保定巨盛模具制造有限公司 网址:http://www.liushuicao.cn  推荐:流水槽模具,流水槽钢模具,排水槽模具,U型槽模具

网站建设及优化保定遨游网络公司