15188633222联系我们
保定巨盛模具制造有限公司
电话：13833064090
电话：15188633222
联系人：高经理
地址：保定市清苑区阎庄乡中阎庄工业区
新闻动态
U型槽成型机的注意要素
U型槽成型机的注意要素：
The attention factor of U type groove forming machine:
1、液压油最适合的油温为30-55度，当油温过低或过高时，水利U型槽机械禁止开机。为调节油温达到最合适的温度，可以使用加热器或冷却器等设备。
1, the most suitable oil temperature of hydraulic oil is 30-55 degrees. When the oil temperature is too low or too high, the U type trough machine is prohibited. To adjust the oil temperature to the most suitable temperature, heater or cooler can be used.
2、液压油一般半年更换一次，更换时要彻底清洗油箱、油管。掖压油变质、变脏会使系统噪音增加，油泵、油缸、换向阀等寿命降低，甚至检查井钢模具 隔离墩模具 隔离墩钢模具 流水槽模具 U型槽模具 螺杆启闭机 卷扬式启闭机 铜雕佛像 使整个系统瘫痪，必须时刻注意。
2, hydraulic oil is usually replaced once a year, and the fuel tank and tubing must be thoroughly cleaned www.huafenchimoju.cn www.mingheertui.com www.luyanshimoju.net.cn www.helesuliao.com www.shidiao820.com www.weishengzhiji.cnwhen replacing. The deterioration of the oil will cause the noise of the system to increase, the life of the oil pump, the oil cylinder and the reversing valve will be reduced, and even the whole system will be paralyzed.
3、要经常检查水利U型槽机械的各润滑点、紧固件等部位。
3, check the lubrication points, fasteners and other parts of water conservancy U groove machinery regularly.
4、水利U型槽机械一般采用抗磨液压油。
4, water conservancy U trough machinery generally uses anti-wear hydraulic oil.
5、空气滤清器、冷却器、油箱及滤油器要经常清洗，使油路畅通。
5, air filters, coolers, oil tanks and oil filters should be cleaned regularly to make the oil passages clea
The attention factor of U type groove forming machine:
1、液压油最适合的油温为30-55度，当油温过低或过高时，水利U型槽机械禁止开机。为调节油温达到最合适的温度，可以使用加热器或冷却器等设备。
1, the most suitable oil temperature of hydraulic oil is 30-55 degrees. When the oil temperature is too low or too high, the U type trough machine is prohibited. To adjust the oil temperature to the most suitable temperature, heater or cooler can be used.
2、液压油一般半年更换一次，更换时要彻底清洗油箱、油管。掖压油变质、变脏会使系统噪音增加，油泵、油缸、换向阀等寿命降低，甚至检查井钢模具 隔离墩模具 隔离墩钢模具 流水槽模具 U型槽模具 螺杆启闭机 卷扬式启闭机 铜雕佛像 使整个系统瘫痪，必须时刻注意。
2, hydraulic oil is usually replaced once a year, and the fuel tank and tubing must be thoroughly cleaned www.huafenchimoju.cn www.mingheertui.com www.luyanshimoju.net.cn www.helesuliao.com www.shidiao820.com www.weishengzhiji.cnwhen replacing. The deterioration of the oil will cause the noise of the system to increase, the life of the oil pump, the oil cylinder and the reversing valve will be reduced, and even the whole system will be paralyzed.
3、要经常检查水利U型槽机械的各润滑点、紧固件等部位。
3, check the lubrication points, fasteners and other parts of water conservancy U groove machinery regularly.
4、水利U型槽机械一般采用抗磨液压油。
4, water conservancy U trough machinery generally uses anti-wear hydraulic oil.
5、空气滤清器、冷却器、油箱及滤油器要经常清洗，使油路畅通。
5, air filters, coolers, oil tanks and oil filters should be cleaned regularly to make the oil passages clea
